It looks like an empty can of progresso soup
The bolts might be allen head screws I think? Also a small chisel to pry the old solenoid off the bracket. Good luck:)
I would purchase one of the do-it-yourself recharge bottles for $20 that comes with a guage pre-installed on the charge hose. It hooks up to the low pressure port on the vehicles A/C system. Careful...Don't go over 60lbs. And into the red zone. Good luck:)
Remember the faster you go, the more it hurts when you fall off a bike. If you adjust the throttle linkage/cable, you will see where it limits the movement on the carb. Linkage. Just remove that small spacer/plate looking thing. You might need a screwdriver and some pliers. Good luck:)
The belt tensioner need to be pulled to the side with a large breaker bar for you to be able to slide the rest of the belt on. See the diagram under the hood or on the radiator area to get a better idea. Good luck:)
On the engine block just behind the lower engine pulley, good luck:)
Engine might run hotter than normal and leak out of the dipstick tube, I would drain a little bit out of the oil pan. Good luck:)
Sounds like an oil seal leak that would cause this. Call up Bass Pro Shops and see what will be a quick fix. Good luck:)
10 to 20 lbs. With small weight lifting circle weights. Enjoy:)
No, only a 12oz. Soda can will be able to support your weight until you tap the side of the can with your finger. Enjoy:)
Use 1/2 a can of CRC brand throttle body cleaner from Pep Boys or Autozone. Good luck:)
Nitrogen was discovered by David Rutherford in 1772. He called it noxious air or fixed air. By the late 18th century, most chemists knew of this fraction of air (nitrogen with some other gases) that did not combust. A few years after 1772, nitrogen was also studied by Carl Wilhelm Scheele, Henry Cavendish, and Joseph … Read more
Remove 16 trans. Pan bolts,◦15mm socket for the drain plug
◦13mm socket for the pan bolts
◦3 inch and/or 6 inch extension
◦universal joint
◦hook type tool to pull the seal out of the transmission housing
◦T40 torx bit for the 2 screws that hold the shift cable bracket to the transmission housing
◦rags and … Read more
Time for a tune-up, plugs, wires, distributor cap/rotor, fuel injector cleaner all might be neede? Good luck:)
Nickelodeon website, that show comes on tonight, I just seen the commercial this morning. Enjoy:)
The ignition tumblers sound like they are getting worn out and causing the key to get stuck. I would try to spray some WD-40 in there with those red straws it comes with, let it soak a couple minutes then try wiggling the key out of there. Good luck:)
The battery is located under the cover immediately behind the Head lamp assembly <DRIVER side> remove the three screws that secure the cover and push the 4 tabs on the heat sink looking with the cords running from it. (I have no idea what this is does)you can now remove this larger cover to reveal … Read more
Power supply
memory slots
fan
computer heatsink/fan
graphics/pci slots on board
cd/dvd drives
front I/O board assembly
disk drives
SATA disk backplane
Good Luck:)