Kenmore washers are built by whirlpool so just go to Whirlpool.com and you can download one from them.

I have had very good luck using Goop creamy hand cleaner, rub it in and then wash as usual, also works well for grease stains.

This could also mean that your injectors are dirty and need to be cleaned.

This could also mean that the injectors are dirty and need to be cleaned.

It will thin out the engine oil and not provide the proper lubrication that your engine needs.

Depending on how much you put in, you should get it changed a.s.a.p. Because it is highly detergent and doesn't have the right lubricating properties for an engine, but it will help clean out any sludge that has built up inside your engine. Just don't drive it any farther than you have to as it … Read more

There is an alternative that you might consider, which is to go to the local auto recyclers and get a used rear axle from wheel to wheel from a late model Expedition or Navigator and that will give you the stuff you need for disc brakes.

Or you can take your VIN to the local Yamaha shop and they can give you a wealth of info. On your bike,

I live in Florida and you can drive in Fl. If you have a licensed driver over 21 with you while you are driving.

Check to make sure that you are getting spark at all the plugs, check to make sure that the firing order is right, check the plugs to make sure they have the proper air gap, check to make sure that the dist. Rotor is actually spinning when you crank it, check to make sure that … Read more

You would have to check with your local D.M.V. To see if they would assign a new one or if you would have to use the one on the frame of the vehicle.

On the engine side of the top radiator hose is where you will find the thermostat housing, take it off, clean off all the old gasket material, pull out the old thermostat, clean off any gasket material there, put in the new one, put on a new gasket (sometimes one would use red permatex gasket … Read more

Depending on how much you put in, if it's only a quart or pint, it will probably be thinned out by the fluid that's already in there and if it wasn't much I wouldn't worry about it. If it was a lot then you should probably get the fluid and filter changed anyway.

Possible cracked piston also.

Chilton motor manuals have them, you can check them out of your local library.

If it is a factory system it will have a fuse in the fuse block, just pull the fuse out. If it is an aftermarket system then you need to find the fuse somewhere in line between the battery and the control unit under the dash, or between the fuse block and the control unit … Read more

Somewhere on the sidewall of the tyres it will have a tire pressure guideline, use the lower pressure for no extra load or the higher pressure if you have junk in the trunk (lol) or a load or if you pull a trailer.